Machine Comparison

Controller	Unit	Iconik	Competitive
Controller Type		Micro Controller	Electronics
Max Electrode Weight	Kg	100	80
Minimum Electrode Wear	%	0.1	<0.3
Best Surface Finish	Ra	0.3	<0.5
Motor Type		Dc survo motor & drive	Micro Stepping & Normal dc stapper
Optimum Working Current	Amps	20+2	20+2
Connected Load	Kva	1.5	<2
Mrr Per Amp	mm³	7	6

Machine Tools

Table Movement	With LM Guide	With Niddle Roller Bearing
All three Axis	With Ball Screw	With Lead screw

Advantages of Micro controller based EDM Logic controller

Switching time is fast
Reduced electronic circuitry and components
Make a Compact controller
Brake down rate is very very low due to reduced electronic circuitry and component
Dou to dc survo motor and drive High speed auto flushing is possibal
Feedback response & corrective action is fast, resulted in higher cutting speed, uniform and good surface finish
Addition of additional features as per the customer’s requirement is easy through software
High speed auto flushing - Specifically helps in deep cavity & complicated profiles, removes the carbon very fast & gives uniform surface finish
Servo motor - DC survo motor and the drive of motor is built-in panal and Movement is controlled precisely as per the requirement of the sparking
All circuit’s blocks are coupled with opto isolators
Higher safety factor
Advanced low wear and super finish circuitry
Provision for fitting the DRO inside the panel box

ICONIK MACHINES

Plot No.- S-76/2/75, near ramleela ground, village peeragarhi, west delhi, Peeragarhi, - 110087, India

Mobile : +91-9717062277, +91-7289881277

Phone : +91-11-42434562